2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario descargar pdf (Pagina 31)

312N TELEKOMUNIKACE a.s., www.2n.cz

Caution

Make sure that the IP address assigned to the SIM card is

public. It is because you will not be able to establish remote

connection to in the STANDALONE mode if an IP2N SmartCOM

address from the provider's internal range is used. The 2N

address need not be public if you use the TCPCLIENT SmartCOM

server connection.

If you know the public IP address, launch the Putty and get connected via port 10000,

which, together with the serial port, can also be used for configuring. Port 10000 is

used for configuration, input data reading and output control in the IP domain. It is in

the command mode upon power up and thus need neither be switched nor restarted

after configuration.

Note

This port requires the safety password if configured so.

Caution

If your fails to respond to incoming TCP connections,2N SmartCOM

check the status of the port to which you are connecting. If the port is

in the command mode, notification on incoming connection is sent to

the line (RING is displayed). Hence, enter the 'ata' command for

answer or set automatic answering by parameter ats0. Refer to the

subsection in the General Commands List of supported AT

below.commands

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 148 149

Sin comentarios

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario Pagina 31