2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario descargar pdf (Pagina 132)

1322N TELEKOMUNIKACE a.s., www.2n.cz

Enter this command to set the port for AT API.

–sLogLevel

Enter this command to set the level for logs. (1 – 5)

–sMaxUser

Enter this command to set the maximum number of users connected to the

server at the same time. The maximum value for the parameter is given by the

licence.

–sMaxTerm

Enter this command to set the maximum number of terminals connected to the

server at the same time. The maximum value for the parameter is given by the

licence.

–sKeepAliveTimeout

Enter this command to set the timeout for the client (user/terminal) to answer

the periodical KeepAlive packet in order not to be disconnected. Select a higher

value if a high number of terminals (100+) are used to avoid disconnection.

–sKeepAlivePeriod

Enter this command to set the interval between the KeepAlive packets. This

number should be higher than the KEEP_ALIVE_TIMEOUT.

–sResetAdmin

Enter this command to reset the Admin user password to '2n'.

-sTerminalPV1url

Sets URL for update of terminals with the SmartCOM protocol version 1 (the

oldest ones). Use parameter '-reset' to reset URL to the default value ('

').http://star.2n.cz/~fejfar/SC_1-3-1-3-2.bin

-sEncryptionKey

Set packet encryption key. 32 hexa characters.

-sEncryptionMode

Set packet encryption mode (0: disabled, 1: optional, 2: forced).

Server commands

–cStartServer

Enter the command to start the Server service. 2N SmartCOM

–cStopServer

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 148 149

Sin comentarios

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario Pagina 132