2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario descargar pdf (Pagina 121)

1212N TELEKOMUNIKACE a.s., www.2n.cz

Let us show you some syntax examples now.

AIN1>50 – the syntax will be marked true in case the value measured on AIN1 is

higher than 50.

– the syntax will be marked true in case the value measured on thePUL2==2596

PUL2 counter is equal to the constant.

the syntax will be marked true in case the DIN1 value is true and theDIN1&&CON3 –

reference condition is also true.

– the syntax will be marked true in case any value higher than 0 is measured on!AIN2

the input.

– the syntax will be marked true in case the value measured on AIN1 isAIN1<=AIN2

lower than the value measured on AIN2.

- the syntax will be marked true (i.e. network failure) in case PING failed or the IPNFG

address was not obtained during the time set at at^scping="interval",<minutes>.

When the IP address is obtained, the state will be cancelled and the condition will

become FALSE.

Caution

If you use Negation, the parameter will be treated as a digital input! It

cannot be expected, for example, that if 50 is measured on AIN1, -50

can be obtained after negation.

To match two inputs use the absolute values obtained from the

converter (ADC 0 - 1020). Therefore, make sure that the two inputs

have been calibrated properly.

Action Types

Insert an action after the separator for the selected syntax.

SAVE

Enter SAVE to save the condition result into the terminal memory for later use.

Note

A typical condition saving AT command looks as follows:

At^scudf="add","AIN1>50:SAVE"

REL1

The action controls the relay 1 state.

REL2

The action controls the relay 2 state.

Note

A typical relay switching AT command looks as follows:

At^scudf="add","AIN1>50:REL1 r[1]"

SMS

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 148 149

Sin comentarios

2n M2M Solution 2N SmartCom - User Manual 1.9.0 Manual de usuario Pagina 121