2n Analogue UMTS gateway 2N SmartGate UMTS - Manual, Manual de usuario Pagina 48

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 83
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 47
Table of Parameters
3.2
48
Setting options: -According to provider (0) - depending on how the
function is selected in the UMTS/GSM network
-Activation (1) - ID is not sent.
-Suppression (2) - ID is always sent.
Default setting: According to provider
Roaming enable/disable Function No.: 702
You can make 2N® SmartGate UMTS work even if it is registered to a foreign
UMTS/GSM network.
Setting options: -Disable (0) -The UMTS/GSM module logs out of a
foreign network and attempts to register again in within
5 minutes.
-Enable (1) - 2N® SmartGate UMTS works in any
UMTS/GSM network.
Default setting: Disable
GPRS APN Function No.: -
GPRS APN (Access Point Name) for automatic setting.
Setting options: 0-40 characters
Default setting: blank
Wireless network selection Function No.: -
Select the type of network used to connection.
Setting options: UMTS+GSM, only UMTS, only GSM
Default setting: UMTS+GSM
Call Handover workaround Function No.: 703
This parameter offers a workaround to prevent problems during call handover
into the 1900 MHz (or 1800 MHz) band, caused by non-conforming
configurations of the 1900 MHz (or 1800 MHz) UMTS/GSM network.
Setting options: -Disable (0) - Disable workaround.
-Enable (1) - Enable workaround. Select only when
handover into a 1800/1900MHz band fails.
Default setting: Disable
Time period for low credit checking [h]Function No.: 710
Set to change time interval between credit checks. If your credit drops under
defined value, 2N® SmartGate UMTS sends SMS "LOW CREDIT". The "0" setting
means that the function is disabled.
Setting options: 0-255 h
Step: 1 h
Default setting: 0
Code for credit checking Function No.: 711
Credit in prepaid SIM cards is checked by network function, which displays text
message on mobile phone display. Code of network function must be terminated
with "#" symbol.
Vista de pagina 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 82 83

Comentarios a estos manuales

Sin comentarios