2n Helios IP Configuration Manual v2.7 Manual de usuario descargar pdf (Pagina 35)

352N TELEKOMUNIKACE a.s., www.2n.cz

List of Parameters

Switch enabled – enable/disable the switch globally. When disabled, the switch

cannot be activated by any of the available codes (including user switch codes),

by a call or quick dial button.

Switch mode – set the monostable/bistable mode for the switch. The switch is

switched off after a timeout in the monostable mode, and switched on with the

first activation and off with the next activation in the bistable mode.

Switch-on duration – set the switch-on time for a monostable switch. This

value is not applied in the bistable mode.

Time profile – assign the switch a time profile to enable switch-on. If the time

profile is inactive, the switch cannot be activated by a code, call or quick dial

button.

Controlled output – assign an electric output to the switch. Choose one of the

available intercom outputs: relay, power output, extender output. If you select

, the switch will not control any electric output but can control externalNone

equipment via HTTP commands.

Output type – if you use the Security Relay module, set the 2N Helios IP

output type to . In the mode, the output works in the inverseSecurity Security

mode, i.e. remains closed and controls the Security Relay module 2N Helios IP

using a specific pulse sequence.

Note

Switch time profiles are available with the Gold or Enhanced Integration

licence only.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 114 115

Sin comentarios

2n Helios IP Configuration Manual v2.7 Manual de usuario Pagina 35