2n EasyGate - User Manual Manual de usuario descargar pdf (Pagina 33)

9. Troubleshooting

No LED is on after power up

· Check the power supply.

All LEDs are on. No call is currently in progress.

· EasyGate is in the special PCManager-based programming mode - exit the

PCManager to reset EasyGate.

· Try to switch EasyGate off and on, the LEDs should go off in 3s and signal the

status of EasyGate.

EasyGate does not register to GSM

· Check the SIM card.

· Check the PIN.

· Check the antenna connection.

· Select a place with a good GSM signal.

No tone can be heard after line off-hook

· Check the telephone line connection.

· EasyGate is not initialized properly upon start (approx. 10s after power up).

· EasyGate is not supplied with power.

EasyGate keeps transmitting a tone during dialing, not receiving the dialing

· Select the correct dialing type (DTMF or pulse).

EasyGate does not communicate with PC

· Check the serial cable connection.

· Check the COM number setting on PC.

· Check the COM parameters (1200-115200 bps, 8N1).

· EasyGate is not registered to GSM network.

· A dialing or outgoing call establishing process takes place on EasyGate.

· An incoming call is ringing on EasyGate.

1 2 ... 28 29 30 31 32 33 34 35 36

Sin comentarios

2n EasyGate - User Manual Manual de usuario Pagina 33