2n EasyGate - User Manual Manual de usuario descargar pdf (Pagina 28)

Routing table enable Function No.: 20

Enable the use of the routing table with this parameter. Disabling this parameter

you put the table out of use.

Setting options: YES/NO

Default setting: NO

Prefix Function No.: -

A prefix identifying the call type (GSM, trunk call, free call, etc.). "Other numbers"

line is used for calls with prefixes that are not included in the table.

Setting options: 0-14 characters (0-9,*,#)

Default setting: blank

Call enable Function No.: -

This parameter allows/bars calls with prefixes included on the same line.

Setting options: YES/NO

Default setting: YES

Number length Function No.: -

The parameter defines the expected length of a number with a prefix included on

the same line. This enables to start dialing into a GSM network immediately after

the last digit is dialed. If the telephone number to be dialed is shorter, a timeout is

respected. The "0" setting means that the function is disabled.

Setting options: 0, 3-15

Setting step: 1

Default setting: 0

End with # Function No.: -

This parameter enables to establish the call when a # is received. The #

character is removed from the dialed number. If a # should be part of the dialed

number, this function cannot be used for the given prefix.

Setting options: YES/NO

Default setting: NO

Remove Function No.: -

The Remove parameter is used for automatic call routing. A defined count of

digits (prefix) is removed from the number beginning.

Setting options: 0-20

Setting step: 1

Default setting: 0

Add Function No.: -

The Add parameter is used for automatic call routing. A defined string (prefix) is

added to the beginning of the number to be dialed.

Setting options: 0-8 characters (0-9,*,#,+)

Default setting: blank

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

2n EasyGate - User Manual Manual de usuario Pagina 28