2n Helios IP Uni v2.1 Manual de usuario descargar pdf (Pagina 21)

212N TELEKOMUNIKACE a.s., www.2n.cz

3.1 Configuration

Helios IP Uni Use a PC equipped with any web browser to configure:

Launch your web browser (Internet Explorer, Firefox, etc.).

Enter the IP address of your intercom (http://192.168.1.100/, e.g.).

You have to know the IP address of your device to log in to the integrated web server.

By default, is switched into the dynamic IP address mode, i.e. it2N® Helios IP Uni

obtains the IP address automatically if a properly set DHCP server is available in your

LAN. If no such DHCP server is available, you can operate in the2N

Helios IP Uni

static IP address mode.

If your device remains inaccessible (you have forgotten the IP address, or the LAN

configuration has changed, for example), change the LAN settings using the buttons on

the device.

IP Address Retrieval

Take the following steps to retrieve the IP address:2N

Helios IP Uni

Connect (or, if connected, disconnect and reconnect) to the2N

Helios IP Uni

power supply.

Wait for the second sound signal .

Press the first quick dial button five times.

Helios IP Uni will read its IP address.

If the address is 0.0.0.0, it means that the intercom has not obtained the IP

address from the DHCP server.

Static/Dynamic Address Setting Mode Switching

In case your device is equipped with 1 or 2 buttons, you can2N

Helios IP Uni

switch the modes using one button only.

Connect to the power supply (or, disconnect and reconnect it2N

Helios IP Uni

if already connected).

Wait for the first acoustic signal .

Press button 1 fifteen times.

The acoustic signal indicates mode switching.

Wait until the device is restarted automatically.

Note

Be sure to press the button sequence within thirty seconds after the

sound signal for security reasons. Up to 2 s intervals are allowed between

the presses.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Sin comentarios

2n Helios IP Uni v2.1 Manual de usuario Pagina 21